Microstation Control Points
When creating a B-spline curve sometimes the points are still visible after you have finished drawing with the tool as shown below.
The display of these control polygons can be turned on and off by using these keyins.
SET INVISGEOM NEVER – will turn off the display of invisible geometry.
SET INVISGEOM ALWAYS – Will turn on the display of invisible geometry.
SET INVISGEOM BYELEMENT – Allows you to set the display of the control polygons depending on if they have been specifically turned on for a particualr element. If you select an element in your drawing and then use the element information tool control polygons can be turned on or off under the Geometry section.
SET INVISGEOM QUERY – Shows the current status for SET INVISGEOM in the status bar.
